PMW20
130
PMW20
131
1.Replace the damaged controller.
2.If the forklift can not work normally, update the program of the main controller. Refer to
7.3.1 for details.
3.Error ID: 02A00
Since the error code of the display is defined variously, read the error
through the host computer.
Cause A
When the maintenance time is up, check it.
Handling Method:
In the item adjustment, change the state of CHECK UP DONE (from ON to OFF). Cancel
the function for alarming maintenance time.
4.Error ID: 02A08
Error Description: WATCHDOG
Since the error code of the display is defined variously, read the error
through the host computer.
Cause A
Watchdog circuit will be activated before software starts. Under working or standby states,
the signal of watchdog is ineffective (warning state).
Handling Method:
A broken state has been seen in the watchdog hardware circuit or the micro-controller
output part. If both of the above two are irrelevant with outer parts, replace the controller.
The operating method is same as that of the error code 02A00.
5.Error ID: 02A09
Error Description: FLASH CHECKSUM
Cause A
The CHECKSUM program fails to save the flash contents.
Handling Method: Re-download the software. If there is still an error, replace the controller.
The operating method is same as that of the error code 02A00.
6.
Error ID: 02A08
Error Description: WATCHDOG 2
The error code of the display is defined variously. Before solving the error, check the
internal error of traction and steering controller.
Cause A
Watchdog circuit will be activated before software starts. Under working or standby states,
the signal of watchdog is ineffective (warning state).
Handling Method:
A broken state has been seen in the watchdog hardware circuit or the micro-controller
output part. If both of the above two are irrelevant with outer parts, replace the controller.
The operating method is same as that of the error code 02A00.
SM-PMW202020001-EN
SM-PMW202020001-EN
To Next Page
Loading...
