BYD PMW20 - Wiring Harness

PMW20
188
PMW20
189
10.3 WIRING HARNESS
10.3.1 LOW-VOLTAGE WIRING HARNESS ASSEMBLY
G01
G02
G03
G04
G05
G06
G07
G08
G09
Connect to port A of the main controller
Connect to port B of the main controller
Connect to port C of the main controller
Connect to port D of the main controller
Connect to the handle wire harness
Connect to the handle limit switch
Connect to the drive motor encoder
Connect to the motor brake lock
Connect to the main contactor
G09A
Connect to the lift limit switch of the fork
G09B
G10
G11
G13
G14
G15
G17
G18
G19
G21
G31
G32
G33
G38
Connect to the lift limit switch of the fork
Connect to the display
Connect to the negative pole of controller
Connect to the lowering proportional valve
Connect to the electric horn
Connect to the relay of the electric horn
Connect to the self-reset ignition switch
Connect to the horn fuse
Connect to the key fuse
Connect to the output end of the main controller
Connect to the connector beside the wire harness
Connect to the temperature sensor of the drive motor
Connect to the time-delay relay
Connect to the diode
H02
H03
Connect to USB
Connect to the 24V reserved connector 1
H04
Ln01
Ln02
Connect to the electric brake relief
Connect to the emergency stop switch
Connect to the emergency stop switch
SM-PMW202020001-EN
SM-PMW202020001-EN