TOTAL LITE Revision 1
SERVICE MANUAL FOR INNOVATION TOTAL LITE Single-Cup Brewer
43
Initial Setup
7.8 Water Temperature
This equipment has a coffee brewing setpoint of 200 °F water temperature to offer a consistent
beverage quality for the users. There is a +/- 2 °F tolerance.
This is an average and is not what you would get from a manual temperature measure. The actual
water temperature uctuates since cold water enters the tank after every beverage delivery and time is
required to heat the incoming water up to the setpoint.
You can also take the water’s brewing temperature manually by ordering a cup of hot water and
measuring its temperature with a thermometer. There may be a slight difference from the tank reading.
This is normal.
If you are experiencing large temperature differences, verify that your tank is clean and not obstructed
by mineral deposits and scale.
Unit safety measures
In the event of a temperature probe failure, the tank may start to boil. This will cause it to overow into
the “Overow Cup” and will automatically shut off the unit.
Electronic
thermostat
To Next Page
Loading...
