TOTAL LITE Revision 1
SERVICE MANUAL FOR INNOVATION TOTAL LITE Single-Cup Brewer
46
7.11 Filter Paper Installation
1. Make sure the power of the brewer is turned
ON;
2. Place the lter paper roll on the support bracket
so that it dispenses on the left hand side; (See
the diagram inside the brewer)
3. Go in service mode (for more informations see
section 6.2) and press the Install lter paper text
box an follow the instructions at the screen; Note:
the brew chamber will not lift up if the switch
does not detect any lter paper
4. Pass it under the left guide bracket of the brew
group, under the brew chamber and under the
wheel guides by gently lifting them using the
yoke;
5. Pull on the paper and carry it through the
cabinet chute hole and into the waste bin;
6. Make sure that it is feeding straight. Verify that
it stays within the rst guide. Improper lter paper
feeding will cause a vacuum leak and may cause
grounds to spill inside the equipment.
Initial Setup
To Next Page
Loading...
