Page 4 - Manual FA01358-EN - 07/2019 - © CAME S.p.A. - The contents of this manual may be changed, at any time, and without notice. - Translation of the original instructions
Danger of high voltage;
Danger of crushing;
Danger of foot crushing;
Danger of hand entrapment;
Do not transit through during maneuvering.
the products that make up the fi nal machinery • set up a suitable dual pole cut o device
along the power supply that is compliant with the installation rules. It should completely
cut o the power supply according to category III surcharge conditions • The gear motor
must be only powered by very low safety voltage, which corresponds to what is stated in
the markings on the gear motor • Keep the section of this manual inside the technical
folder along with the manuals of all the other devices used for your automation system.
Remember to hand over to the end users all the operating manuals of the products that
make up the fi nal machinery.
The next fi gure shows the main hazard points for people.
Page 4 - Manual FA01358-EN - 07/2019 - © CAME S.p.A. - The contents of this manual may be changed, at any time, and without notice. - Original instructions
To Next Page
Loading...
Need help?
General
