Canon DC330 - Preparations

ONCE THE BATTERY PACK IS FUllY CHARGED
1 Disconnect the compact power
adapter from the camcorder.
2 Unplug the power cord from the
power outlet and the compact
power adapter.
To REMOVE THE BATTERY PACK
Press [BATT.] to release the battery
pack. Slide the battery pack down
and then pull it out.
__ IMPORTANT
• Turn off the camcorder before
connecting or disconnecting the
compact power adapter. After you turn
the
~ switch to _, important file
allocation data
is updated on the disc.
Be sure to wait until the
PLAY and
CAMERA mode indicators
are
completely off.
•
You may hear some noise from the
compact power adapter during use. This
is not a malfunction.
•
We recommend charging the battery
pack in temperatures between 10°C and
30 °C
(50 OF and 86 OF). Outside the
temperature range of 0 °C to
40°C
(32 OF to 104 OF), the charging will not
start.
•
Do not connect to the camcorder's DC
IN terminal or to the compact power
adapter any electrical equipment that is
not expressly recommended for use with
this camcorder.
• To prevent equipment breakdowns and
excessive heating, do not connect the
supplied compact power adapter to
voltage converters for overseas travels or
special power sources such
as those on
aircraft and ships, DC-AC inverters, etc.
20 • Preparations
CD NOTES
• The CHARGE indicator also serves as a
rough estimate of the charge status.
Continuously on: Battery pack fully
charged.
Two quick flashes at 1-second intervals:
Battery pack at least 50% charged. If the
indicator flashes quickly but not exactly
in this pattern, refer to Troubleshooting
([IJ 79).
One flash at 1-second intervals: Battery
pack less than 50% charged.
•
We recommend that you prepare battery
packs to last 2 to 3 times longer than you
think you might need.
• U.S.A. and Canada only: The
lithium ion/polymer battery
that powers this product is
recyclable. Please call
1-800-8-BATIERY for
information on how
to recycle this
battery.
Preparing the Wireless Controller and
Accessories
Using the Wireless Controller
First, insert the supplied lithium button
battery CR2025 into the wireless
controller.
1 Press the tab in the direction of the
arrow and pull out the battery
holder.