- Finalize
the
disc
using
the
camcorder
(CO
49).
- DVD-RW
discs
in
VR
mode
can only be
played
back
with
VR
mode-compatible
DVD players. Refer
to
the
instruction
manual
of
your DVD device.
Cannot edit my recordings or add
recordings to the disc with the DVD
device.
- It
may
not
be possible
to
edit
or
add
recordings with an external DVD
recorder on a
disc
recorded with this
camcorder.
Memory Card Operation
Memory card cannot be inserted.
- Memory card is
not
facing
the
correct
direction. Turn the memory card over
and reinsert it
(CO
29).
Cannot record on the memory card.
-
Memory
card is full. Erase still images
(CD
56)
to
free
some
space
or
replace
the
memory
card.
-
Memory
card was
not
initialized.
Initialize
the
memory
card
(CD
60).
- The folder and file numbers have
reached their maximum value. Set
[FILE NOS.]
to
[RESET]
(CD
77) and
insert a
new
memory card.
- The write-protect switch on an
SO
or
SDHC memory card is set
to
prevent
accidental erasure. Change
the
position
of
the
write-protect
switch.
Memory card cannot be played back.
- Set
the
camcorder
to
CPLAY',D)
mode
(CD
54).
Image cannot be erased.
- Image is protected. Cancel
the
protection (OJ
59).
- The
write-protect
switch
on an SO
or
SDHC memory card is set
to
prevent
accidental erasure. Change the position
of
the
write-protect
switch.
[Q
appears
in
red.
- A memory card error occurred. Turn off
the
camcorder. Remove and reinsert
the
memory
card.
Initialize
the
memory
card
(II)
60) if
the
icon still appears in
red.
82 •
Additional
Information
Printing
The printer
is
not operating even though
the camcorder and printer are correctly
connected.
- Disconnect
the
USB cable and turn
off
the
camcorder
and the printer. After a
short while, turn
them
on again, set
the
camcorder
to
CfliAl~'D1
mode
and
restore
the
connection.
List
of
Messages
(in
alphabetical
order)
CANNOT ENTER THE
@)
STANDBY
MODE
NOW
- The camcorder cannot enter
the
Quick
Start
standby
mode
(CD
34) while the
disc
is being recognized after it was
inserted
or
if
the
remaining battery
charge is
too
low.
CANNOT PLAY BACK
- The
disc
is dirty
or
you
attempted
to
play
back
a
disc
type
not
supported
by
this
camcorder
(not DVD-RJRW)
or
a
disc
that
is dirty
or
scratched.
- This message can also appear if
condensation has formed. Wait until
the
camcorder
dries completely before
resuming use
(II)
90).
CANNOT READ THE DISC
CHECK THE DISC
- Disc could
not
be read. Try cleaning it
or
replace
the
disc
(CD
87).
- This message can also
appear
if
the
camcorder
has exceeded its
operational temperature. Turn off
the
camcorder
and let it cool
down
before
resuming use.
- This message can also appear if
condensation has formed. Wait until
the
camcorder
dries completely before
resuming use
(CO
90).
- The
disc
may
not
be loaded correctly.
Try removing the
disc
and reinserting it
(CO
27).
To Next Page
Loading...
