~
SYSTEM
SETUP
[WL.REMOTE]
[SPEAKER
VOL.]
•
[BEEP]
[
18m
HIGH
VOLUME],
•
• •
•
[18>
LOW
VOLUME],
[mJ
OFF]
[POWER
SAVE]
.
[m
ON],
[mJ
OFF]
•
• •
•
..........
[@
STANDBY
OFF]
[m.
10
min],
[mm
20
min],
•
•
[mllIIlI
30
min]
[FILE
NOS.]
[13
RESETl,
[=
CONTINUOUS]
•
[TV
TYPE]
[mJ
NORMAL
TVl,
[0]
WIDE
TV]
•
• •
•
[FIRMWARE]
•
[WL. REMOTE]: Allows the camcorder to be operated with the wireless controller.
[SPEAKER VOL.]: Adjust (
.....
~)
the volume
of
the playback.
[BEEP]: A beep will accompany some operations like turning on the camcorder, the self-
timer countdown, etc. It also serves as a warning beep under unusual conditions.
[POWER SAVE]:
In
order
to
save power when the camcorder
is
powered by a battery
pack, it will automatically shut off if left without any operation for 5 minutes. Approximately
30 seconds before the camcorder shuts off, the
message"
&AUTO
POWER OFF" will
appear.
[@)
STANDBY OFF]: Select the length
of
time after which the camcorder will end the
standby
mode
and shut
off
automatically.
[FILE NOS.]: Select the image numbering method
to
be used when you insert a new
memory card.
Images are automatically assigned consecutive image numbers from
0101
to 9900, and
stored
in
folders containing up
to
100 images. Folders are numbered from
101
to 998.
[13
RESET]: Image numbers will restart from 101-0101 every time you insert a new
memory card.
[=
CONTINUOUS]: Image numbers will continue from the number following that
of
the
last image recorded with the camcorder.
• If the memory card you insert already contains an image with a larger number, a new
image will be assigned a number one higher than that
of
the last image on the memory
card.
•
We
recommend using the
[=
CONTINUOUS] setting.
[TV TYPE]:
In
order
to
display the picture
in
full and
in
the correct aspect ratio, select the
setting according
to
the type
of
television to which you will connect the camcorder.
[~
NORMAL TV): TV sets with 4:3 aspect ratio.
[mE
WIDE TV): TV sets with 16:9 aspect ratio.
[FIRMWARE]:
You
can verify the current version
of
the camcorder's firmware. This menu
option is usually grayed out.
Additional
Information
•
77
I
To Next Page
Loading...
