I I I I
• CANNOT RECORD
• CANNOT RECORD
CHECK THE DISC
- There is a problem with the disc.
Replace the disc (OJ 27).
- This message can also appear if
condensation has formed. Wait until the
camcorder dries completely before
resuming use (OJ 90).
- The disc's recording surface may be
dirty or scratched.
- This message may appear when the
camcorder is repeatedly subject to
vibration.
CANNOT USE DISC
USE OF A RECOMMENDED DISC IS
ADVISED
- The disc cannot be used.
We
recommend that you use a disc that
has been tested (OJ
6).
CARD ERROR
- A memory card error occurred. The
camcorder cannot record
or
display the
image. The error may be temporary. If
the message disappears after 4
seconds and
Od
appears
in
red, turn
the camcorder off, remove the card and
reinsert the card. If
Od
changes to
green, you can resume recording/
playback.
CARD FULL
- Memory card is full. Erase some images
(OJ 56)
to
free some space
or
replace
the memory card.
CHANGE THE BATTERY PACK
- Battery pack is exhausted. Replace
or
charge the battery pack (OJ 19).
DISC ACCESS FAILURE CHECK THE
DISC
- There was
an
error when reading the
disc or attempting to write onto it.
Try
cleaning the disc
or
replace it (OJ 87).
- This message can also appear if
condensation has formed. Wait until the
camcorder dries completely before
resuming use (OJ 90).
- The disc may not be loaded correctly.
Try removing the disc and reinserting it
(OJ 27).
DISC COVER IS OPEN
- Verify the disc is correctly inserted and
close the disc cover (OJ 27).
DISC FULL
- The disc is full
("0
END" appears on
the screen). Delete some recordings
(DVD-RW
in
VR
mode)
to
free some
space (OJ
37)
or
replace the disc.
DISC IS FINALIZED
CANNOT RECORD
-
You
cannot record additional scenes on
a finalized DVD-R/DVD-R DL disc.
-
You
cannot record additional scenes
or
unfinalize a DVD-RW disc
in
VIDEO
mode that was finalized with another
digital device.
DISC
MUST
BE
FINALIZED TO PLAY
BACK IN COMPATIBLE PLAYERS
- Be sure to finalize the disc and check
the compatibility of the device before
playing back the disc on external
DVD
devices (OJ 49).
LOADING THE DISC
- The disc is being read. Wait before you
start recording.
NAMING ERROR
- The folder and file numbers have
reached their maximum value. Set the
[FILE NOS.] option to [RESET] and
erase all the images on the memory
I
card (OJ
56)
or
initialize it (OJ 60).
NO CARD
- There is no memory card
in
the
camcorder (OJ 29).
NO DISC
- No disc is loaded. Insert a disc
(OJ 27).
- This message can also appear if
condensation has formed. Wait until the
camcorder dries completely before
resuming use (OJ 90).
NO
IMAGES
- No images are recorded on the memory
card.
~
PRINT ORDER ERROR
-
You
attempted
to
set more than 998 still
images
in
the print order (OJ 64).
Additional
Information
• 83
To Next Page
Loading...
