REACHED THE
MAXIMUM
NUMBER OF
SCENES
- The maximum number of scenes has
been reached. Delete some recordings
(DVD-RW in
VR
mode) to free some
space
(Q]
37)
or replace the disc.
RECOVERING
DATA
PLEASE WAIT...
- Data on the disc
is
being recovered.
Wait until this message disappears
before resuming use.
TASK IN PROGRESS DO NOT
DISCONNECT THE POWER SOURCE
- The camcorder is updating important
file allocation data on the disc. Do not
disconnect the compact power adapter
or remove the battery pack.
• TEMPERATURE TOO HIGH CANNOT
RECORD
• TEMPERATURE TOO HIGH CANNOT
REMOVE DISC
- The camcorder has exceeded its
operational temperature. Disconnect
the compact power adapter and
remove the battery and let the
camcorder cool
down
before resuming
use.
TOO
MANY
STILL IMAGES
DISCONNECT USB CABLE
Disconnect the USB cable and decrease
the number of still images on the memory
card to less than 1,800. If a dialog
appeared on the computer screen, close
it and then restore the connection.
~
TRANSFER ORDER ERROR
You
attempted to set more than 998
transfer orders
(Q]
70).
UNABLE TO RECOGNIZE THE
DATA
- The disc may not be recognized by this
camcorder if it was initialized with a
different
device.
-
You
inserted a disc recorded
in
a
different Television System
(PAL
or
SECAM).
UNABLE TO RECOVER
DATA
- Could not recover a corrupted file.
- This message can also appear if
condensation has formed. If you
suspect condensation
is
the reason,
do
not initialize the disc and wait until the
84
•
Additional
Information
camcorder dries completely before
resuming use
(Q]
90).
UNFINALIZE THE DISC
-
You
cannot record additional scenes on
a finalized DVD-RW in VIDEO mode.
Unfinalize the disc first
(Q]
50).
USE OF A RECOMMENDED DISC IS
ADVISED
- The disc can be used but performance
is
not guaranteed.
We
recommend that
you use a disc that has been tested
(Q]
6).
Direct
Print
Related
Messages
About Canon PIXMAISELPHY
DS
Printers: If the printer's error indicator
flashes or
an
error message appears on
the printer's operation panel, refer to the
printer's instruction manual.
CANNOT PRINT!
-
You
attempted
to
print
an
image that
was recorded with another camcorder,
with a different compression, or was
edited on a computer.
COMMUNICATION ERROR
- The printer is experiencing a data
transfer error. Cancel printing.
Disconnect the USB cable and turn off
the camcorder and the printer. After a
short while, turn them on again, set the
camcorder
to
(P,LAY~O:)
mode and
restore the connection. If you
attempted to print from a memory card
that contains a large number
of
images,
reduce the number
of
images.
COULD NOT PRINT X IMAGES
-
You
attempted to use the print order
settings to print X images that were
recorded with another camcorder, with
a different compression or were edited
on a computer.
FILE ERROR
-
You
attempted
to
print
an
image that
was recorded with another camcorder,
To Next Page
Loading...
