Canon imageCLASS D480 - Checking;Deleting Fax Reception Documents; Checking the Fax Log

Fax
5-46
Checking/Changing the Status of Fax Documents in Memory
Checking/Deleting Fax Reception
Documents
You can delete the received documents in memory.
You can also forward received documents in
memory to a desired destination.
1
Press [Job Cancel/Status Monitor]
repeatedly to select <TX/RX STATUS>,
then press [OK].
T X / R X S T A T U S
2
Press [ ] or [ ] to scroll trough the
job list.
0 3 1 X X X X X X X
0 0 1 M E M O R Y T X
If you want to delete a job, go to the next step.
Otherwise, press
[Stop/Reset] to return to the
standby mode.
3
Press [ ] or [ ] to select the job you
want to delete, then press [OK].
1 2 3
0 0 1 R X
Ex.
4
Press [ ] or [ ] to select <CANCEL>,
then press [OK].
C A N C E L
0 0 1
You can forward the selected job to another
destination by selecting <FORWARD>. For
information on forwarding received documents,
see “Forwarding Received Fax Documents in
Memory,” on p. 5-44.
5
Press [ ] to select <YES>.
< Y E S N O >
C A N C E L ?
If you do not want to cancel the job, press [ ]
to select <NO>.
6
Press [Stop/Reset] to return to the
standby mode.
Checking the Fax Log
You can view the results of fax transactions that list
all faxes sent or received.
1
Press [Job Cancel/Status Monitor]
repeatedly to select <TX/RX LOG>, then
press [OK].
T X / R X L O G
2
Press [ ] or [ ] to view the required
transmission/reception result.
1 2 3 X X X X X X - O K
6 0 ( 0 7 / 3 1 1 4 : 0 4 ) T X
Ex.
3
Press [Stop/Reset] to return to the
standby mode.