Canon imageCLASS D480 - Basic Copying Method

Copying
4-4
Basic Copying Method
Basic Copying Method
This section describes the basic procedure for copying.
1
Place documents on the platen glass or
load them in the ADF.
For details, see “Placing Documents,” on p. 2-4.
Close the ADF/platen glass cover after placing
your documents.
For documents you can copy, see “Documents
Requirements,
” on p. 2-2.
2
Press [COPY].
If you want to adjust the image quality, see
“Selecting Image Quality,
” on p. 4-6.
If you want to adjust the density, see
“Adjusting Density”
on p. 4-8.
If you want to adjust the zoom ratio, see
“Enlarge/Reduce Images”
on p. 4-10.
If you press and hold [OK] in the copy mode, a
sample page will be printed. For details, see
“Printing a Sample Page” on p. 4-24.
–
–
–
–
–
–
3
Use – [numeric keys] to enter the
desired copy quantity (1 to 99).
T E X T / P H O T O 1
1 0 0 % L T R
Ex.
The copy quantity appears on the right
side of the display.
If you make a mistake when entering
values, press [Clear] and enter the correct
values.
You cannot change the copy quantity while the
machine is copying.
4
Press [Start].
–
–