Note
•
If the Tab Selection screen is not displayed, press the Menu button.
2
Press the OK button.
The Paper Menu is displayed.
3
Press â–² or â–¼ to select Paper Details, and then press the OK button.
4
Press â–² or â–¼ to select the type of paper, and then press the OK button.
5
Press â–² or â–¼ to select Trim Edge First, and then press the OK button.
6
Press â–² or â–¼ to select the desired setting option, and then press the OK button.
This setting takes effect the next time you load a roll.
Reducing Dust from Cutting Rolls
Reducing Dust from Cutting Rolls
For media such as Backlit Film that are more likely to generate debris when cut, select CutDustReduct. > On in
the Paper Menu of the Control Panel. This option reduces debris from cutting by printing black lines at the leading
and trailing edges of documents. It may help prevent Printhead damage. You can specify for CutDustReduct. to be
activated for particular types of paper.
Important
•
Do not set CutDustReduct. to On for paper that wrinkles easily, such as Plain Paper or lightweight paper. This
may impair cutting and cause paper jams.
•
Borderless printing is not available when CutDustReduct. is set to On. To use borderless printing, select Cut-
DustReduct. > Off.
Set CutDustReduct. to On as follows.
1
On the Tab Selection screen of the Control Panel, press â—€ or â–¶ to
select the Paper tab ( ).
Note
•
If the Tab Selection screen is not displayed, press the Menu button.
2
Press the OK button.
The Paper Menu is displayed.
3
Press â–² or â–¼ to select Paper Details, and then press the OK button.
4
Press â–² or â–¼ to select the type of paper loaded in the printer, and then press the OK button.
5
Press â–² or â–¼ to select CutDustReduct., and then press the OK button.
iPF685
Reducing Dust from Cutting Rolls
User's Guide
Handling and Use of Paper Handling rolls
357
To Next Page
Loading...
Need help?
General