EasyManuals Logo

Canon imagePROGRAF iPF685 User Manual

Canon imagePROGRAF iPF685
642 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #530 background imageLoading...
Page #530 background image
2
On the Tab Selection screen of the Control Panel, press â—€ or â–¶ to
select the Settings/Adj. tab ( ).
Note
•
If the Tab Selection screen is not displayed, press the Menu button.
3
Press the OK button.
The Set./Adj. Menu is displayed.
4
Press â–² or â–¼ to select Adjust Printer, and then press the OK button.
5
Press â–² or â–¼ to select Feed Priority, and then press the OK button.
6
Press â–² or â–¼ to select Adj. Priority, and then press the OK button.
7
Press â–² or â–¼ to select Automatic, Print Quality, or Print Length, and then press the OK button.
Automatic Banding Adjustment
Automatic Banding Adjustment
If printed images are affected by banding in different colors across the sheet, execute Adj. Quality for automatic
adjustment of the paper feed amount.
There are two modes of automatic adjustment to correct banding: Auto(GenuinePpr) and Auto(OtherPaper). In
either mode, the printer prints and reads a test pattern for automatic adjustment of the feed amount.
•
Auto(GenuinePpr)
Use this mode with paper identified in the Paper Reference Guide.
(See "Types of Paper.") ➔P.328
•
Auto(OtherPaper)
Use this mode with paper not in the Paper Reference Guide, or if Auto(GenuinePpr) does not eliminate
banding.
(See "Types of Paper.") ➔P.328
Note
•
Always check the Adj. Priority values before using Auto(GenuinePpr) or Auto(OtherPaper).
(See "Selecting a Feed Amount Adjustment Method.") ➔P.529
•
Adjustment is not possible with Auto(GenuinePpr) and Auto(OtherPaper) when using highly transparent media.
In this case, use Manual adjustment.
(See "Manual Banding Adjustment.") ➔P.531
•
If additional fine-tuning is necessary after Auto(GenuinePpr) and Auto(OtherPaper), execute Adj. Fine Feed.
(See "Fine-Tuning the Paper Feed Amount.") âž” P.533
•
Use Adjust Length to ensure that lines in CAD drawings are printed at exactly the right length.
(See "Adjusting Line Length.") ➔P.533
•
This may take some time, depending on the type of paper.
•
Use paper of the same type and size for adjustment as you will use for printing.
Items to Prepare
When Using Rolls An unused roll at least 10 inches wide
When Using Sheets Auto(GenuinePpr) : One sheet of unused paper, A4/Letter size
Auto(OtherPaper) : Two sheets of unused paper, A4/Letter size (or one sheet when using A2)
Automatic Banding Adjustment
iPF685
User's Guide
Adjustments for Better Print Quality Adjusting the feed amount
530

Table of Contents

Other manuals for Canon imagePROGRAF iPF685

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Canon imagePROGRAF iPF685 and is the answer not in the manual?

Canon imagePROGRAF iPF685 Specifications

General IconGeneral
BrandCanon
ModelimagePROGRAF iPF685
CategoryPrinter
LanguageEnglish

Related product manuals