2
Tape down printer covers to secure them, in the reverse
order of tape removal during installation.
3
Remove the Stand by reversing the installation procedure, when it was attached to the printer.
4
Disassemble and repackage the Stand by following the installation procedure in reverse.
5
Repack the Roll Holder, Holder Stopper, and printer in shipping materials, and then package them in a
shipping box.
Reinstalling the Printer
Reinstalling the Printer
The basic workflow for reinstalling the printer is as follows.
For detailed instructions, see the Setup Guide.
Assemble the stand (optional)
1
If you are using the optional Stand, assemble the Stand by
referring to the Printer Stand Setup Guide included with the
Stand.
Caution
•
The Stand must be assembled by at least two people on a flat surface. Attempting assembly by yourself
poses a risk of injury or bending the Stand.
•
When assembling the Stand, lock all four of the casters. Attempting to move the stand when the casters
are not locked poses a risk of injury or damage to the location site.
•
Before moving the assembled stand, lift the sup-
port rod to the position shown (a) and unlock all
four casters. Moving the stand with the support rod
lowered or the casters locked may cause injury or
damage the area of installation or basket cloth.
iPF685
Reinstalling the Printer
User's Guide
Maintenance and Consumables Other Maintenance
567
To Next Page
Loading...
Need help?
General