EasyManuals Logo

Canon imagePROGRAF iPF685 User Manual

Canon imagePROGRAF iPF685
642 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #454 background imageLoading...
Page #454 background image
The Set./Adj. Menu is displayed.
3.
Press â–² or â–¼ to select Interface Setup, and then press the OK button.
4.
Press â–² or â–¼ to select Ethernet Driver, and then press the OK button.
5.
Press â–² or â–¼ to select MAC Address, and then press the OK button.
Note
•
If the Tab Selection screen is not displayed, press the Menu button.
•
You can investigate the MAC address by printing an interface setting report.
(See "Printing Interface Setting Reports.") ➔P.431
2
In Windows, open a command prompt, or in Mac OS, start Terminal.
3
Execute the following command to add entries to the ARP table for managing IP addresses and corre-
sponding MAC addresses.
arp -s [IP address] [the printer's MAC address you have verified]
Example: arp -s xxx.xxx.xxx.xxx 00-1E-8F-xx-xx-xx
Note
•
In Mac OS when using Terminal, enter the arp command in the format arp -s xxx.xxx.xxx.xxx 00:1E:
8F:xx:xx:xx. For details, refer to the help file for the command line.
4
Execute the following command to send the IP address to the printer and configure it.
ping [IP address as specified in the ARP command] -l 479
Example: ping xxx.xxx.xxx.xxx -l 479
Note
•
In -l, the l is the letter l.
•
In Mac OS when using Terminal, enter the ping command in the format ping -s 479 xxx.xxx.xxx.xxx. For
details, refer to the help file for the command line.
Note
•
The subnet mask and default gateway are set to 0.0.0.0. Use RemoteUI to change the subnet mask and default
gateway to match your network settings.
For details on RemoteUI, see "Using RemoteUI." ➔P.450
Configuring TCP/IPv6 Network Settings
Configuring TCP/IPv6 Network Settings
When printing in a TCP/IPv6 network, you must configure the TCP/IPv6 settings on the Control Panel.
Follow the steps below to configure the TCP/IPv6 network settings.
1
On the Tab Selection screen of the Control Panel, press â—€ or â–¶ to
select the Settings/Adj. tab ( ).
Note
•
If the Tab Selection screen is not displayed, press the Menu button.
2
Press the OK button.
The Set./Adj. Menu is displayed.
3
Press â–² or â–¼ to select Interface Setup, and then press the OK button.
4
Press â–² or â–¼ to select TCP/IP, and then press the OK button.
5
Press â–² or â–¼ to select IPv6, and then press the OK button.
Configuring TCP/IPv6 Network Settings
iPF685
User's Guide
Network Setting Initial Settings
454

Table of Contents

Other manuals for Canon imagePROGRAF iPF685

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Canon imagePROGRAF iPF685 and is the answer not in the manual?

Canon imagePROGRAF iPF685 Specifications

General IconGeneral
BrandCanon
ModelimagePROGRAF iPF685
CategoryPrinter
LanguageEnglish

Related product manuals