9
In the A Page Size list, click the size of the original as specified in the application. In this case, click ISO
A4.
10
Select the C Enlarged/Reduced Printing check box.
11
Click ISO A4 in the G Paper Size list.
12
Click F Scaling and enter 120.
Note
•
You can specify enlargement that exceeds the paper size, but in this case, the portions off the bottom and
right edges of the paper will not be printed.
•
If the original size after enlargement or reduction is
smaller than the paper size, the original is printed in
the upper-left corner. In this case, you can center
originals by selecting E Print Centered on the Lay-
out sheet.
13
Confirm the print settings and print as desired.
Note
•
For tips on confirming print settings, see "Confirming Print Settings ." ➔P.145
Resizing Originals by Entering a Scaling Value (Mac OS)
Resizing Originals by Entering a Scaling Value (Mac OS)
This topic describes how to enlarge originals before printing by entering a scaling value, based on the following
example.
•
Document: Any Type
•
Page size: A4 (210.0 × 297.0 mm [8.3 × 11.7 in])
•
Paper: Roll paper
•
Paper type: Plain Paper
•
Roll paper width: A2/A3 roll (420.0 mm [16.5 in])
iPF685
Resizing Originals by Entering a Scaling Value (Mac OS)
User's Guide
Enhanced Printing Options Printing enlargements or reductions
67
To Next Page
Loading...
Need help?
General