Other Maintenance
Other Maintenance
Preparing to Transfer the Printer ..................................................................................................................... 564
Reinstalling the Printer .................................................................................................................................... 567
Updating the Firmware ................................................................................................................................... 570
Preparing to Transfer the Printer
Preparing to Transfer the Printer
To protect the internal parts in transit, always follow these steps before transferring the printer to a new location.
Refer to the Setup Guide for details on packing the printer and installing it after transfer.
Important
•
Avoid tilting the printer excessively in transit. This may cause ink in the printer to leak and cause stains.
Note
•
When you execute prepare to transfer, ink is drawn into the Maintenance Cartridge. Depending on the amount of
free space in the mounted Maintenance Cartridge, you may need to replace it with a new one at this time.
Note that replacement is not required if there is 80% or more free space. (See "Checking the Remaining Mainte-
nance Cartridge Capacity.")
➔P.558
•
Depending on the state of the printer, part replacement may be necessary when preparing to transfer the printer
(that is, when you execute the printer menu item to prepare for transfer).
Remove paper
1
Remove the paper.
•
Rolls (See "Removing the Roll from the Printer.") ➔ P.345
•
Sheets (See "Removing Sheets.") ➔ P.363
Access the Prep.MovePrinter menu
1
If a message instructing you to replace the Maintenance Cartridge is displayed on the Display Screen, re-
place the Maintenance Cartridge.
(See "Replacing the Maintenance Cartridge.") ➔ P.554
2
On the Tab Selection screen of the Control Panel, press ◀ or ▶ to
select the Settings/Adj. tab ( ).
Note
•
If the Tab Selection screen is not displayed, press the Menu button.
3
Press the OK button.
The Set./Adj. Menu is displayed.
4
Press ▲ or ▼ to select Prep.MovePrinter, and then press the OK button.
5
Press ▲ or ▼ to select Standard or Limited, and then press the OK button.
Displays the confirmation screen.
Important
•
If Limited is selected, do not transport in low temperature environments. The ink remaining in the printer
may freeze and damage the printer.
Preparing to Transfer the Printer
iPF685
User's Guide
Maintenance and Consumables Other Maintenance
564
To Next Page
Loading...
