Canon LBP6030B - Page 77

Changing the port type or number
If the printing protocol (LPD or RAW) has been changed on the machine side ( Configuring Printing Protocols and Web
Services) or the port number has been changed (
Changing Port Numbers), the corresponding settings on the computer must
also be configured. This operation is not needed for WSD ports.
MFNP port
Standard TCP/IP port
When the next screen is displayed, follow the instructions on the screen.
When you select the [Device Type], select [Canon Network Printing Device with P9100] under [Standard].
5
Click [Finish].
6
Click [Close].
*
1
Click [Configure Port].
2
Under [Protocol Type], select [RAW] or [LPR], and change the [Port Number].
3
Click [OK].
1
Click [Configure Port].
2
Under [Protocol], select [Raw] or [LPR].
If you selected [Raw], change the [Port Number].
If you selected [LPR], enter "lp" in [Queue Name].
㻣㻣㻌㻛㻌㻞㻝㻥