93
Contents
Preparation/
Setup
Print Using a
Computer
Appendix
IndexPrint/SaveInput/Edit
Names of
Components
Maintenance/
Printer Settings
Trouble-
shooting
■
Changing the Cut Depth for Full Cut
The cut depth for the full cut can be set for each print media. The default setting is set to
"Normal."
[Example] The full cut of the tube is not cut properly, so make the cut one step deeper.
1
Press the [Option] key.
2
Use [ ] or [ ] o select "Print adjust" and press the [Enter] key.
File
Print adjust
Setting
Option
3
Use [ ] or [ ] to select " Full Cut Depth," and press the [Enter] key.
ɻɻ
Adjustments
Half Cut Depth
Half Cut Motion
Full
Cut Depth
4
Use [ ] or [ ] to select "Tube," and press the [Enter] key.
ɻɻ
Normal
Normal
Normal
ShrinkTube
Label
Tube
Full Cut Depth
5
Use [ ] to select "Deep 1" and press the [Enter] key.
Full Cut Depth can be set in four levels: "Deep
(1~3)," "Normal."
Each time you press [
], the cut is deepened by
one step.
ɻɻ
Full Cut Depth
[ Deep 1 ]
To Next Page
Loading...
