Canon MK3000 - Adjusting the Cut Depth; Adjusting the Cutter Depth

91
Contents
Preparation/
Setup
Print Using a
Computer
Appendix
IndexPrint/SaveInput/Edit
Names of
Components
Maintenance/
Printer Settings
Trouble-
shooting
Adjusting the Cut Depth
If the cutter blade is becoming less sharp or half cutting is too deep, adjust the depth of the cut.
Adjustment can be set for both "Half cut" and "Full cut."
■
Changing the Cut Depth for Half Cut
The cut depth for half cut can be set for each print media. The default setting is set to "Normal."
NOT
E
• If cutting is di cult depending on the material of the print media, adjust the motion of the cut.
(P.96)
[Example] The half cut of the label tape is too deep (or too shallow), so adjust the half cut
depth.
1
Press the [Option] key.
2
Use [ ] or [ ] to select "Print adjust" and press the [Enter] key.
File
Print adjust
Setting
Option
3
Use [ ] or [ ] to select " Half Cut Depth," and then press the [Enter] key.
ɻɻ
$GMXVWPHQWV
Half Cut Depth
Half Cut Motion
Full Cut Depth
4
Use [ ] or [ ] to select "Label," and press the [Enter] key.
Label
Clear Tube
WrapAround
Half Cut Depth
Normal
Normal
Normal