Troubleshooting
Cannot
Print
Properly
from
the Digital
Camera
The
following
are
the possible errors that
may
occur when printing directly from a
digital still camera or digital video camcorder*,
and
the countermeasures to
eliminate them.
* Hereafter, the digital still camera and digital video camcorder are collectively
called a digital camera or camera.
W Notes
• PictBridge or Canon Bubble
Jet
Direct compatible
digital
cameras
can
be
connected
to your printer for direct printing.
• This section describes errors
that
are indicated on Canon brand PictBridge- or
Bubble
Jet
Direct-compatible cameras.
The
error messages and operations may vary
depending
on
the camera you are using.
If
you cannot clear the error
on
your device,
check the error message displayed
on
the
LCD
of
the printer, and then clear it.
For
details,
see
"An Error Message is Displayed
on
the
LCD"
on
page 75.
• A communication time
out
occurs
if
printing takes a longtime or
if
it
takes too much
time
to
send data. This may stop printing.
In
such a case, disconnect the cable
between the printer and the camera, and reconnect the cable between the printer
and the camera. Then, turn the camera on,
jf
it
does not automatically turn on.
If
the
problem is still unresolved, select some other photo and check
if
it
can
be
printed or
not.
• Depending
on
the model or brand
of
your device, you may have to select a print
mode compatible with PictBridge before connecting the device.
You
may also have
to
turn
on
the device or select Play mode manually after connecting the device to the
printer.
Perform necessary operations according to the instruction manual supplied with
your device.
•
The
Print
Head
Nozzles may be clogged
if
printing becomes faint or colors are
incorrect.
See
"Printing
is
Blurred/Colors are Wrong/White Streaks appear"
on
page 78.
•
If
the paper is curled or its surface is scratched during printing, make sure
that
you
are using the correct type
of
paper.
If
this error occurs
even
when you are using the correct type
of
paper, slide the
Paper Thickness
lever
to the left.
See
"Printed Surface is Scratched or Ink Blots"
on
page 79.
•
To
disconnect the cable connected between the digital camera and printer, follow
the procedure below.
1 Disconnect the cable from the printer.
2 Turn
off
the digital camera.
3 Disconnect the cable from the digital camera.
When disconnecting the cable, be sure to hold the connector
by
its sides.
•
For
the errors indicated
on
the camera and their solution, also refer to the user's
manual
of
the camera.
For
other troubles on the digital camera, contact the
manufacturer
of
the camera.
81
To Next Page
Loading...
