Cardinal 210 Installation And Technical Manual

8200-M585-O1 Rev D  210 Installation & Technical 53
SETUP AND CALIBRATION, CONT.
Sio (Sio?) - Serial Input/Output
With Sio (Sio?) displayed, press the ENTER key. The display will change to show the
current setting no. To skip configuring the Sio (serial input/output) and proceed to the
Print? menu, press the ENTER key again. To configure the Sio, press the numeric key
1/YES (display will change to YES) and then press the ENTER key. After pressing the ENTER
key, the display will change to
Sio 0? (Setup Serial Port 0)
Press the ENTER key. The display will change to show the current setting no. To skip
configuring the Sio Port 0 (serial input/output) and proceed to the Sio 1? menu, press
the ENTER key again. To configure the Sio 0, press the numeric key 1/YES (display will
change to YES) and then press the ENTER key.
bAUd0= (Serial Port 0 Baud Rate)
Press the ENTER key to show the current value. If the setting displayed is acceptable, press
the ENTER key again to save it. Otherwise, use the numeric keys to enter a new baud rate for
the serial ports, then press the ENTER key to save it. Allowable values are:
12 = 1200 Baud 24 = 2400 Baud 48 = 4800 Baud
96 = 9600 Baud 14 = 14.4k Baud 19 = 19.2k Baud
28 = 28.8k Baud 38 = 38.4k Baud 57 = 57.6k Baud
76 = 76.8k Baud 11 = 115.2k Baud 23 = 230.4k Baud
Prty0= (Serial Port 0 Parity)
Press the ENTER key to show the current value. If the setting displayed is acceptable, press
the ENTER key again to save it. Otherwise, using the numeric keys enter the new setting,
then press the ENTER key to save it. Allowable values are: 0, 1, or 2.
0 = NONE (No Parity) 1 = Odd Parity 2 = Even Parity
bitS0= (Serial Port 0 Data Bits)
Press the ENTER key to show the current value. If the setting displayed is acceptable, press
the ENTER key again to save it. Otherwise, using the numeric keys enter the new setting,
then press the ENTER key to save it. Allowable values are: 7 or 8.
StoP0= (Serial Port 0 Stop Bits)
Press the ENTER key to show the current value. If the setting displayed is acceptable, press
the ENTE
R key again to save it. Otherwise, using the numeric keys enter the new setting,
then press the ENTER key to save it. Allowable values are: 1 or 2.
Cont0= (Continuous Output Serial Port 0)
Press the ENTER key to show the current value. If the setting displayed is acceptable, press
the ENTER key again to save it. Otherwise, using the numeric keys, 0/NO or 1/YES, enter the
new setting, then press the ENTER key to save it.
Cont0= YES Cont0= no
Continuous Output No Continuous Output
If Cont0= YES (Continuous Output) is selected, an additional prompt, tYPE0=
will be displayed.
If Cont0= no (No Continuous Output) is selected, proceed to the Weight On
Demand section.

Cardinal 210 Specifications

General

Brand	Cardinal
Model	210
Category	Accessories
Language	English