8200-M585-O1 Rev D 210 Installation & Technical 52
SETUP AND CALIBRATION, CONT.
oper = 6 (Livestock Weigher)
id= (ID Prompt)
The id= prompt enables an ID prompt before printing a ticket.
With the display showing id=, press the ENTER key to show the current value. If the
setting displayed is acceptable, press the ENTER key again to save it. Otherwise, using the
numeric keys, 0/NO or 1/YES, enter the new setting, then press the ENTER key to save it.
id=1 (Yes) id=0 (No)
id= will be displayed when PRINT key is
pressed and printed on the ticket.
Normal print operation (no ID prompt) will
occur.
If you selected id=1 (Yes, ID Prompt), an additional prompt, "a clr=" will be displayed.
If you selected id=0 (No ID Prompt) proceed to A-d (A-d?) Analog to Digital Filtering.
A cLr= (Auto Clear ID)
The a clr= (Auto Clear ID) prompt determines whether the ID is automatically cleared
after printing the ticket. Note that it is only displayed when id= YES is selected.
With the display showing a clr=, press the ENTER key to show the current value. If the
setting displayed is acceptable, press the ENTER key again to save it. Otherwise, using the
numeric keys, 0/NO or 1/YES, enter the new setting, then press the ENTER key to save it.
A clr=1 (Yes) a clr=0 (No)
Automatically clears the ID after the
ticket has printed.
ID is not cleared when ticket prints
and can be used for next transaction.
Setup your desired ticket format using the print tabs in the setup menu. Below is the list of
selectable print tabs along with a brief print tab description.
hoUr= Prints the current time
dAtE= Prints the current date
id= Prints the keyed ID
CnC n= Prints the consecutive number (ticket number)
GroSS= Prints the stable Gross weight
G ACC= Prints the Gross weight accumulator
CoUnt= Prints the keyed animal head count
AErG= Prints the average animal weight if there’s a stored head count
CrLF= Select YES to append a LF to each printed line
EoP= Number of new lines to append at the end of a ticket
To Next Page
Loading...
Need help?
General
