8200-M585-O1 Rev D 210 Installation & Technical 3
PRECAUTIONS
Static Electricity
CAUTION! This device contains static sensitive circuit cards and components.
Improper handling of these devices or printed circuit cards can result in damage to or
destruction of the component or card. Such actual and/or consequential damage IS
NOT covered under warranty and is the responsibility of the device owner. Electronic
components must be handled only by qualified electronic technicians who follow the
guidelines listed below.
WARNING! ALWAYS use a properly grounded wrist strap when handling, removing
or installing electronic circuit cards or components. Make certain that the wrist strap
ground lead is securely attached to an adequate ground. If you are uncertain of the
quality of the ground, you should consult a licensed electrician.
ALWAYS handle printed circuit card assemblies by the outermost edges. NEVER
touch the components, component leads or connectors. ALWAYS observe warning
labels on static protective bags and packaging and never
remove the card or
component from the packaging until ready for use. ALWAYS store and transport
electronic printed circuit cards and components in anti-static protective bags or
packaging.
To Next Page
Loading...
Need help?
General
