8200-M585-O1 Rev D 210 Installation & Technical 64
SETUP AND CALIBRATION, CONT.
nEt= (Net Weight Print Location)
Press the ENTER key to show the current setting for the location of Net weight printing. If the
setting displayed is acceptable, press the ENTER key again to save it. Otherwise, use the
numeric keys to enter a new location and then press ENTER to save it.
G ACC= (Gross Weight Accumulator Print Location)
Press the ENTER key to show the current setting for the location of Gross weight accumulator
printing. If the setting displayed is acceptable, press the ENTER key again to save it.
Otherwise, use the numeric keys to enter a new location and then press ENTER to save it.
n ACC= (Net Weight Accumulator Print Location)
Press the ENTER key to show the current setting for the location of Net weight accumulator
printing. If the setting displayed is acceptable, press the ENTER key again to save it.
Otherwise, use the numeric keys to enter a new location and then press ENTER to save it.
CoUnt= (Count "number of pieces on the scale" Print Location)
Press the ENTER key to show the current setting for the location of Count (number of pieces
on scale) printing. If the setting displayed is acceptable, press the ENTER key again to save it.
Otherwise, use the numeric keys to enter a new location and then press ENTER to save it.
EACH= (Piece Weight Print Location)
Press the ENTER key to show the current setting for the location of Piece weight printing. If
the setting displayed is acceptable, press the ENTER key again to save it. Otherwise, use the
numeric keys to enter a new location and then press ENTER to save it.
CrLF= (Carriage Return Line Feed) - Data Format Termination
Data transmitted from the serial I/O port can be terminated with a single carriage return and
either no line feed or a single line feed command. Press the ENTER key to view the current
setting. A YES on the display means the data will be terminated with a carriage return AND a
line feed while a no on the display means the data will be terminated with a single carriage
return only.
If the setting displayed is acceptable, press the ENTER key again to save it. Otherwise, using
the numeric keys, 0/NO or 1/YES, enter the new setting, then press the ENTER key to save it.
EoP= (End-Of-Print Line Feeds)
At the end of a data transmission to a printer, the indicator can transmit a pre-selected number
of line feed commands to space the paper in the printer to the desired position for withdrawal
or for the next print.
Press the ENTER key to view the current setting. If the displayed value is acceptable, press
the ENTER key to save it. Otherwise, use the numeric keys to enter the new the number of
End-Of-Print linefeeds, then press the ENTER
key to save the new setting. Allowable values
are:
0 through 99.
To Next Page
Loading...
Need help?
General
