8200-M585-O1 Rev D 210 Installation & Technical 88
DIGITAL FILL CONTROL MODE OPERATION, CONT.
Auto Trim
Auto Trim option is a feature that will automatically adjust the trim weight value, after every
completed fill operation, to achieve accurate fill weights. For example, if the preset SLO=
weight is set at 5000 lbs and the TRin= is set at 100 lbs, the cut-off will be at 4900 lbs. If
the actual weight of the trim is 50 lbs, the total weight of the material discharged will be 4950
lbs, not 5000. With Auto Trim enabled, starting with the next operation, the TRin= value will
be gradually adjusted until the 5000 lbs preset weight total is achieved. Depending on how
much difference there is between the programmed trim and the actual trim, it may take several
operations before the full preset weight amount is reached.
Auto Print
This feature, when enabled, produces an automatic print of the delivered net or gross weight at
the end of each fill operation. The following is an example of the information printed.
14:54 12/13/2012
#53
12000 lb G
00 lb T
12000 lb N
SINGLE SPEED OPERATION
USING STORED ID DFC SETTINGS:
To recall the stored settings from memory (setup parameter StOr?=YES), press the PRESET
key. The display will show StOr=, press the ENTER key, the current ID (if any) will be
displayed. If the displayed ID is correct, press the ENTER key, otherwise, enter the desired ID
and press ENTER. If a new ID was entered, the Fill weight and trim weight will be retrieved
from memory.
The display will change to show FiLL=, press the ENTER key and the current fill weight will
be displayed. If this value is acceptable press the ENTER key, otherwise, use the numeric
keys to enter a new fill weight and press the ENTER key.
The display will change to show TRin=, press the ENTER key and the current trim weight will
be displayed. If this value is acceptable press the ENTER key, otherwise, use the numeric
keys to enter a new trim weight and press the ENTER key.
NOTE: If the Fill or trim values are changed, they will NOT be saved to the ID in memory.
If the dGAtE=YES, then the display will change to 0toL=. Press the ENTER key and the
current zero tolerance weight will be displayed. If this value is acceptable press the ENTER
key, otherwise, use the numeric keys to enter a new zero tolerance weight and press the
ENTER key.
The current Gross/Net weight will be displayed.
To Next Page
Loading...
Need help?
General
