8200-M698-O1 Rev B 225 Installation and Technical
135
SCALE ID
The Scale ID is used with the 2XX-USBA Option Card to identify the scale/indicator in the
Transaction Storage file. Note that up to 99 scale/indicator can be indentified.
With the indicator ON, press the SHIFT key and then press the Navigation ENTER key (red
square key in center of the Navigation arrows). The display will change to show the
SETUP/REVIEW MENU.
SETUP/REVIEW MENU
1.ENTER CALIBRATION AND SETUP
2.VIEW AUDIT TRAIL COUNTERS
3.CALIBRATE SCALE 1 8.SCALE ID=00
9.DEL CUSTOM TICKET
10.PRINT SETUP
Enter Selection: 1 ^ EXIT
8.SCALE ID=00(Scale ID)
With the SETUP/REVIEW MENU displayed, press the 8 key and then the ENTER key. The
display will change to show the Scale ID prompt.
With the Scale ID prompt displayed the current setting will be shown. If the setting
displayed is acceptable, press the ENTER key to return to the SETUP/REVIEW MENU.
Otherwise, use the numeric keys to enter the new Scale ID and then press the ENTER key
to save the new setting. Allowable values are: 0 through 99.
Press EXIT (Navigation Keys UP Arrow) to reset the indicator and return to normal
operations.
To Next Page
Loading...
