Cardinal 225 - Page 74

8200-M698-O1 Rev B  225 Installation and Technical
66
CALIBRATION AND SETUP, CONT.
12. G ACCUM=YY.XX (GROSS WEIGHT ACCUMULATOR PRINT LOCATION)
With PRINT TABBING MENU #2 displayed the current setting for the G ACCUM=
parameter will be shown. Note that YY.XX is the current position for printing of the
Gross weight accumulator. If the position displayed is acceptable, proceed to the next
setup parameter.
Otherwise, press the 1 and 2 keys, the ENTER key and then using the numeric keys,
enter the new print position and then press the ENTER key to save the new setting and
return to PRINT TABBING MENU #2.
13. N ACCUM=YY.XX (NET WEIGHT ACCUMULATOR PRINT LOCATION)
With PRINT TABBING MENU #2 displayed the current setting for the N ACCUM=
parameter will be shown. Note that YY.XX is the current position for printing of the Net
weight accumulator. If the position displayed is acceptable, proceed to the next setup
parameter.
Otherwise, press the 1 and 3 keys, the ENTER key and then using the numeric keys,
enter the new print position and then press the ENTER key to save the new setting and
return to PRINT TABBING MENU #2.
14. COUNT=YY.XX (COUNT (NUMBER OF PIECES ON SCALE) PRINT LOCATION)
With PRINT TABBING MENU #2 displayed the current setting for the COUNT=
parameter will be shown. Note that YY.XX is the current position for printing of the
Count (number of pieces on scale). If the position displayed is acceptable, proceed to
the next setup parameter.
Otherwise, press the 1 and 4 keys, the ENTER key and then using the numeric keys,
enter the new print position and then press the ENTER key to save the new setting and
return to PRINT TABBING MENU #2.
15. PCS WT=YY.XX (PIECE WEIGHT PRINT LOCATION)
With PRINT TABBING MENU #2 displayed the current setting for the PCS WT=
parameter will be shown. Note that YY.XX is the current position for printing of the
Piece weight. If the position displayed is acceptable, proceed to the next setup
parameter.
Otherwise, press the 1 and 5 keys, the ENTER key and then using the numeric keys,
enter the new print position and then press the ENTER key to save the new setting and
return to PRINT TABBING MENU #2.