6
revision 0 date: 07/19 doc. AG525990
6.6.3 - Sostituire ltri olio trasmissione (I e II
pompa)
ATTENZIONE: non eseguire il cambio
dell'olio mentre l'olio è caldo, poiché esiste
il rischio di lesioni.
ATTENZIONE: prima di lavorare sui ltri
dell’olio idraulico, assicurarsi che l’olio
idraulico sia freddo. Indossare guanti
protettivi impermeabili. In caso contrario, si
vericano rischi di ustioni, lesioni e / o problemi
di salute
6.6.3 - Replace transmission oil lter (I and II
pump),
CAUTION: Do not perform the oil change
while the oil is hot, as there is the risk of
injury.
CAUTION: Before working on hydraulic oil
lters, ensure that the hydraulic oil is cold.
Wear impervious protective gloves.
Otherwise risk of burns, injuries and/or health
problems occurs.
1. Disconnect the Battery.
2. Arrange a suitable container for collecting the
hydraulic oil.
3. Unscrew the hydraulic lter bowls (A) and (B)
using a lter wrench.
4. Remove the lter cartridges (C) and (D).
5. Properly clean the lter bowls (A) and (B) and
their seats.
6. Apply a lm of oil on the gaskets.
7. Install new lter cartridges (C) and (D).
8. Ret the lter bowls (A) and (B), and tighten to the
specication torque of 70 N·m (51.62 lb·ft).
9. Restore the transmission oil level with proper oil,
check lubricant table (chapter 8.1) in the manual
10. Reconnect the Battery.
11. Run the engine for several seconds.
12. Check the hydraulic oil level.
13. Check for leaks.
To Next Page
Loading...
