3
revision 0 date: 07/19 doc. AG525990
3.29 INTERVENIRE SUI PNEUMATICI IN
SICUREZZA
3.30 SERRAGGIO VITI / DADI DI FISSAGGIO
DELLE RUOTE
3.31 PARCHEGGIARE IL TRATTORE IN
SICUREZZA
3.32 TRAINO DEL VEICOLO
ATTENZIONE: Nel caso risulti impossibile
avviare il motore, consultare un’ocina
autorizzata per conoscere le possibilità di
rimorchio con motore spento.
3.29 SERVICING TYRES SAFELY
Explosive separation of a tire and rim parts can cause
serious injury or death. Do not attempt to mount a tire
without the proper equipment and experience to perform
the job. Always maintain the correct tire pressure. Do
not inate the tires above the recommended pressure.
Never weld or heat a wheel and tire assembly. The
heat can structurally weaken or deform the wheel or
lead to tire explosion. When inating tires, use a hose
long enough to allow you to stand to one side and not
in front of the tire.
Use a protection cage, if necessary and available.
Check tires for low pressure, cuts, bubbles, damaged
rims or missing lug bolts and nuts.
3.30 TIGHTENING WHEEL NUTS AND BOLTS
Tighten all wheel nuts and bolts at the intervals
specied in the relevant section.
3.31 PARKING THE TRACTOR SAFELY
Before working on the machine:
• Lower any implement possibly connected to the
ground.
• Engage the parking brake.
• Stop engine and remove key.
• Disconnect battery negative cable.
• Set a warning panel saying ‘DO NOT USE’ in the
driving place.
3.32 TOWING THE VEHICLE
The best way to move a faulty tractor is to carry it on
the bed of a truck. In case of towing need, comply with
the following instructions:
• Start the engine (idle speed)
CAUTION: If it is not possible to start the
engine, consult an authorised workshop to
nd out the possibility of towing with the
engine o.
• Take reverser lever to neutral.
• Set power take-o to neutral.
To Next Page
Loading...
