6
revision 0 date: 07/19 doc. AG525990
6.9.3 - Front PTO - Replace oil and oil lter6.9.3 - PTO anteriore - Sostituire l’olio e ltro
olio
1. Place the tractor on a at, horizontal surface.
2. Apply the parking brake and stop the engine.
3. Remove key from the key switch.
4. Lift the hood.
5. Place a suitable container under the drain plug
(1).
6. Unscrew the cap (2).
7. Once all the oil has drained out, reinstall the plug
(1).
8. Unscrew the screws (3) and remove cover (4).
9. Pull out and replace the oil lter.
10. Replace the O-ring.
11. Fit the cover (3) complete with O-ring.
12. Introduce the new oil into the PTO through the
hole in the cap (2). For quantity and type of oil see
chapter 8.1 Lubricant table.
13. Screw the closure cap (2).
14. Start the engine and let it run for a few minutes.
15. Stop the engine.
16. Unscrew the cap (2) and check the oil level which
in normal conditions must reach the edge of the
hole. Top up if necessary.
1.
2.
3. i accensione
4.
5.
6.
7.
8.
9.
10.
11.
12.
1
2
3
4
To Next Page
Loading...
