6
66
revision 0 date: 07/19 doc. AG525990
Modello V / V model
Pneumatico posteriore
Rear tyre
Pressione di gonaggio (bar)
Ination pressure (bar)
Pneumatico anteriore
Front tyre
Pressione di gonaggio (bar)
Ination pressure (bar)
Modello VLB / VLB model
Pneumatico posteriore
Rear tyre
Pressione di gonaggio (bar)
Ination pressure (bar)
Pneumatico anteriore
Front tyre
Pressione di gonaggio (bar)
Ination pressure (bar)
ATTENZIONE: non sostare nei pressi del
pneumatico durante il gonaggio. Rischio
di esplosione.
CAUTION: Do not stay next to tyre while
inating it. Explosion hazard.
- Inate tyres at the pressure specied by the
manufacturer
- Regularly check tyre pressure
- Check tyre wear conditions (sides and tread)
- Have maintenance and repair be carried out by
authorised sta only.
6.10.9 Ruote - Vericare la coppia
di serraggio delle viti del cerchio e della ruota
6.10.10 Ruote - Controllare la pressione di
gonaggio dei pneumatici
6.10.9 Wheels - Check torque of
wheel and rim bolts
This operation must be done by an authorised service
centre.
6.10.10 Wheels - Check tyre ination
pressure
Tyres life and performance depend on the correct
ination pressure. Insucient pressure leads to tyre
early wear. Excessive pressure impairs grip and
increases wheel skidding. Correct tyre pressure
not only depends on work conditions and load, but
even on tractor model and tyre size and brand. It is
then recommended to ask advice to dealer or tyre
manufacturer.
Check tyre pressure every 100 hours. Important: To
obtain good results when working in the eld, where
maximum grip is required, tyre ination pressure could
be reduced up to 0.8 bar (11 psi) maximum. Please
note that in this case loading capacity is greatly
reduced. Ination pressure of front and rear tyres shall
always comply the values indicated in the specication
chart. These values could be reduced proportionally
up to allowed limits where this is required in order to
ensure correct mechanical matching of front and rear
wheels.
To Next Page
Loading...
