Editing
If editing is enabled (X.3 parameter 15), data held in a local buffer may be
edited using the delete character (parameter 16) and the buffer may be
deleted using the buffer delete character (parameter 17). In addition the
contents of the buffer may be displayed using the buffer display character
(parameter 18).
4.4.4.5 Configure Terminal Profiles Menu (
conf prof term or conf tp
command)
Router : Watford CONFIGURE TERMINAL PROFILES MENU Rel x.y
--------------------------------------------------------------------------------
----------------- ----------------- ----------------- -----------------
|1 ||2 ||3 ||4 |
| VT100 | | ADM3A | | IBM3101 | | CIFER 2605 |
----------------- ----------------- ----------------- -----------------
----------------- ----------------- ----------------- -----------------
|5 ||6 ||7 ||8 |
||||||||
----------------- ----------------- ----------------- -----------------
ED - Edit CO - Copy CL - Clear VI - View
--------------------------------------------------------------------------------
PF2 - Help PF4 - Main Menu
PF3 - Prev Menu
--------------------------------------------------------------------------------
(conf tp) Enter action:
This menu displays eight profiles at a time. When a profile has a name, it
is also displayed; if not, only the number is shown.
You can specify an action to be carried out on a terminal profile. Once
selected, you are prompted to specify the profile(s) required.
The edit action requests a single profile, and enters the Configure
Terminal Profile form. The copy action requests two profiles, a source
profile and a destination profile: the contents are then copied (except the
name). The clear action requests a single profile and then clears it to the
initial default values. The view action enters the Configure Terminal
Profile form but does not allow the form to be submitted. Abort must be
used to leave the form.
X870-300351 Issue 1 4-24 Rev.0
To Next Page
