Case 845B VHP - Page 50

CHAPTER 3 – INSTRUMENTS AND CONTROLS
3-10
I. WARNING MAIN INDICATOR LIGHT (YELLOW, NON-CRITICAL
The warning main indicator light is an indicator for non-critical warnings. Refer to “Non-Critical Warning
Indicator Lights”.
Non-Critical Warning Indicator Lights
When the warning light turns on, alter the operation mode, program an interruption for the maintenance works or, if the
condition persists, contact your dealer. The following table lists some of the warnings that may be shown on the cluster
assembly, and the necessary corrective action.
When a failure occurs, a sound alarm is heard for 3 seconds and the YELLOW warning main indicator light turns on
and is displayed on the message area. When this occurs, take the machine back to the working location and stop the
engine to avoid onerous repair risks.
Non-Critical Warnings
Display Description Corrective Action
PARKING BRAKE Parking brake engaged and shift
lever to F or R.
Apply the brake pedal.1.
Release the parking brake pedal before putting transmission selec-2.
tor lever in forward or reverse.
COOLANT
TEMPERATURE
High engine
coolant temperature.
Idle machine and monitor temperature.1.
Clean radiator or operate fan reverser (If equipped).2.
Check the coolant level and add coolant if necessary.3.
If condition persists, contact your dealer.4.
HYDRAULIC FLUID
TEMPERATURE
High hydraulic
uid temperature.
Idle machine and monitor temperature.1.
Clean hydraulic uid cooler or operate fan reverser. (If equipped)2.
Check hydraulic uid level.3.
If condition persists, contact your dealer.4.
TRANSMISSION FLUID
TEMPERATURE
High transmission uid
temperature.
Idle machine and monitor temperature.1.
Clean transmission cooler or operate fan reverser. (If equipped)2.
Use a lower gear.3.
If condition persists, contact your dealer.4.
AIR FILTER High air lter restriction. Clean air lter.1.
Replace primary and secondary lters.2.
If condition persists, contact your dealer.3.
TRANSMISSION FILTER Transmission lter high
restriction.
Replace transmission lter.1.
If condition persists, contact your dealer.2.
HYDRAULIC FILTER Hydraulic lter high
restriction.
Replace hydraulic lter.1.
If condition persists, contact your dealer.2.
ALTERNATOR Alternator malfunction. Check electrical system.1.
Voltages are out of range.2.
Change operating procedure.3.
If condition persists, contact your dealer.4.
FUEL Low fuel level. Fill fuel tank as soon as possible. 1.