DANGER:
Do
not permit any part of the machine to come in
contact with electric cables. If work must be done near electric
cables, first make sure the Utility Company disconnects the power. It
h.
is not necessary for the machine to be in contact with the electric
.. cable for the electricity to go through the machine. If the machine
does come in contact with
a
power line, stay in the seat.
Do
not try to
get off the machine. KEEP AWAY FROM THE METAL PARTS OF
THE MACHINESee the chart that follows. 4-4-8
Voltage of
Minimum Amount of
Minimum Amount of
Electric Cables
Clearance from the
Clearance from the
Electric Cables When the
Electric Cables When
Machine is Working
You Drive the Machine
Between Jobs
50,000 volts or less
10 feet (3 m)
4 feet (1.2 m)
Over 50,000 volts
10 feet (3 m) plus
1/2
inch
10 feet (3 m)
(10 mm) for every 1.000
345,000 - 750,000
volts over 50,000 volts
16 feet (5 m)
volts
NOTE:
If the clearances in the specifications above are less than the
clearances given in the rules and laws of your area, you must follow the rules
and laws of that area.
WARNING:
Keep the transmission in low gear when going down
h.
hills. Only use the right brake pedal to slow or stop the machine. The
,,'eft
brake pedal allows the machine to freewheel before the brake is
applied.
Do
not allow the machine to freewheel down the hill.
22-2-A
9
To Next Page
Loading...
