Case W14 - Page 123

Replacing Ether Starting Fluid Can
(Late Production Models)
IMPORTANT: Before replacing a container of Case Starting fluid, read
the information and warnings on the can.
A3.
4.
5.
6.
7.
WARNING: An explosion can result if sparks or flame contact the
ether in the starting fluid container, or if you keep the container in an
area with the temperatures above 120° F (49° C). Read the following.
1.
2.
Know the correct method for starting your engine with ether.
tt you weld, grind, or use a cutting torch on the machine, always
remove the starting fluid container from the machine. Use com-
pressed air to remove any ether fumes from the area.
Do not breathe the ether vapor or let the ether touch your skin.
Keep the starting fluid container above the reach of children.
Never make a hole in the starting fluid container.
Do not put the starting fluid container in a fire.
When the temperature is above 35° to 40° F (0° to 5° C) remove
the starting fluid container from the machine.
Failure to follow the above procedure can cause a severe injury.
48-12-C
To install a 15 oz. (.44 litre) container of Case Starting fluid, proceed as
follows:
1. Loosenthe lock nut and put the top holes of the bail extensions on the tabs
of the cold start body.
121