2. Remove the safety cap and plastic spray nozzle from the fluid can.
3. Position the fluid can on the locknut and tighten the lock nut.
1. Cold Start Body
2. Starting Fluid Can
3. Lock Nut
4. Bail
5. Tab
6. bail Extension
When the temperature is warm and the engine does not require assistance
to start, do the following.
1. Remove the can of Case Starting Aid from the machine.
2. Install the can holder on the cold start body.
3. Tighten the lock nut so the bottom of the cold start body is sealed.
122
To Next Page
Loading...
