47
14.6 Getting Started (continued)
We are back at attempting to Read all Parameter Set-
tings and Model Features from an existing device.
The controller is properly connected and the converter
is recognized by your PC.
(See 12.5 for troubleshooting suggestions).
From the Confirm Settings to Connect window,
choose which communication port (Configuration Port
or RS485 Port) and the respective Port Settings (COM1
or COM7 for example). Select [ OK ]
The progress of the device reading will be displayed
in the Communications Progress window. The device
reading should take approximately 10 seconds.
Upon a successful reading from your device, you will
see that the Outputs and Options displayed in the
ChromaTemp Configurator Option Selection window
are now the same as your controller.
Parameter value changes may be made within the
Configuration Software program. These changes may
be saved to a file, downloaded to the controller, or hard
copy printed for review.
14.6 Getting Started