49
Read in Your Hardware
Read in Parameter Configuration
If you are working online with your instrument, press
, then check and adjust Units’ Com-
munication Port, the PC COM port number, and if using
RS485, enter the correct Address, Baudrate, Databits
and Parity (as currently setup in your instrument).
Then press to read in your 1020 Controller
hardware options.
This step reads in the hardware settings
from the connected unit but not the param-
eter settings.
Before reading in the parameters, first up-
load the hardware options (see above).
Then press to read in the current settings from
the unit.
Make Configuration Changes
Edit the configuration to your requirements.
Write to Unit
Press to download your new configuration to
the unit.
Save Changes to File
Press to save any changes to a file if you wish to
use it later.
Loading in Older Configuration Files
The ChromaTemp configurator may give a warning
when loading in a file from older versions of the con-
figurator.
If you open this file you need to consider that the Unit
Information-Details section may not be complete or
correct.
Opening files in older versions of the configurator will
not give a warning message but can give misleading
information in the Details.
For example, see screenshot where the DoM is July
2014.
Details
To Next Page
Loading...
Need help?
General
