TABLE OF CONTENTS
SECTION 1:
SAFETY INSTRUCTIONS AND WARNINGS ....................................................... 1-1
1.01 Arc Welding Hazards ....................................................................................... 1-1
1.02 Principal Safety Standards .............................................................................. 1-4
1.03 Declaration of Conformity ............................................................................... 1-5
1.04 Symbol Chart .................................................................................................. 1-6
1.05 Servicing Hazards ........................................................................................... 1-7
1.06 EMF Information ............................................................................................. 1-8
SECTION 2:
INTRODUCTION ...................................................................................... 2-1
2.01 How to Use This Manual ................................................................................. 2-1
2.02 Equipment Identification ................................................................................. 2-1
2.03 Receipt of Equipment ...................................................................................... 2-1
2.04 Description ..................................................................................................... 2-1
2.05 Transportation Methods .................................................................................. 2-1
SECTION 3:
SAFETY AND INSTALLATION ....................................................................... 3-1
3.01 Duty Cycle ....................................................................................................... 3-1
3.02 Specifications ................................................................................................. 3-2
3.03 Environment ................................................................................................... 3-3
3.04 Location .......................................................................................................... 3-3
3.05 High Frequency Introduction .......................................................................... 3-3
3.06 High Frequency Interference ........................................................................... 3-4
3.07 Electromagnetic Compatibility ........................................................................ 3-4
3.07 Volt-Ampere Curves ........................................................................................ 3-6
SECTION 4:
OPERATION ........................................................................................... 4-1
4.01 WELDSKILL 200AC/DC Power Source Controls, Indicators and Features ....... 4-1
4.02 WELDSKILL 200AC/DC - STICK Programming Mode ..................................... 4-6
4.03 WELDSKILL 200AC/DC – LIFT TIG and HF TIG Programming Mode ............. 4-7
4.04 Short Circuit Protection While Welding ......................................................... 4-10
4.05 Shielding Gas Regulator Operating Instructions ........................................... 4-11
4.06 Setup for TIG (GTAW) Welding ..................................................................... 4-13
4.07 Foot Control, Part No. W4015800 (Optional Accessory) ............................... 4-14
4.08 Setup for STICK (MMAW) Welding ............................................................. 4-16
SECTION 5:
THEORY OF OPERATION ............................................................................ 5-1
5.01 Inverter Design ............................................................................................... 5-1
To Next Page
Loading...
