CIGWELD WeldSkill 200AC/DC - Control Board Removal

WELDSKILL 200AC/DC INVERTER DISASSEMBLY PROCEDURE
Disassembly Procedure 7-2 Manual 0-5206
7.03 Control Board Removal
!
Read and follow safety information in Section 6.02 before proceeding with disassembly
Remove case (refer to 6.04) before remove control board.
1. M4 Screw. Remove 4 screws from control panel.
2 Disconnect DRIVE harness from DRIVE connector.
3. Disconnect J8 harness from J8 connector
4. Disconnect SOURCE harness from SOURCE connector.
5. Disconnect SS harness from SS connector.
6. Disconnect GUN harness from GUN connector.
7. Disconnect SOU harness from Sou connector.
8. Disconnect IGBT OT harness from IGBT OT connector.
9. Disconnect QF/HF harness from QF/HF connector.
10. Disconnect WVIN harness from WVIN connector.
11 Disconnect JB harness from JB connector.
12. Disconnect ACP OUT harness from ACPOUT connector.
13. Disconnect WA harness from WA connector.
Ensure to unplug all harness from the main control PCB.
1011
1
23
45
6
7
8
9
13
12
A-11432