CIGWELD WeldSkill 200AC/DC - Installing Control Board

ASSEMBLY PROCEDURE WELDSKILL 200AC/DC INVERTER
Manual 0-5206 8-7 Assembly Procedures
8.09 Installing Control Board
1. Install 4 screws.
2. Plug harness into DRIVE connector.
3. Plug harness into J8 connector.
4. Plug harness into POWER connector.
5. Plug harness into SS connector.
6. Plug harness into GUN connector.
7. Plug harness into SOU connector.
8. Plug harness into OT connector.
9. Plug harness into QF/HF connector.
10. Plug harness into WV connector.
11. Plug harness into JB connector.
12. Plug harness into ACPOUT connector.
13. Plug harness into WA connector.
1011
1
23
45
6
7
8
9
13
12
A-11432