CipherLab 1564 User Manual

100
Enter Setup
1564 Barcode Scanner User Guide
3.1 CONNECTING VIA 3656
By default, the interface of 3656 is set to “USB HID”. Use the interface cable to connect
the scanner via 3656 to PC. You can have up to seven scanners connected to one
computer at the same time.
Note: If you are using USB Virtual COM for the first time, you must install its driver from
the CD-ROM. Driver version 5.3 or later is required. Please remove older versions!
3.1.1 CONNECT TO 3656
You can connect any scanner to 3656 by having the scanner read the two labels at the
back of 3656. The scanner will respond with one beep upon reading each of the labels.
 “Set Connection” label
 “Serial Number” label
After reading these labels, the scanner will stay active for a specified period of time (2
minutes by default) trying to connect to the 3656 stand while its LED is flashing blue
(On/Off ratio 0.5 s: 0.5 s). Once connected, the scanner will respond with three beeps
(tone ascending from low to high), and the LED becomes flashing blue (On/Off ratio 0.02
s: 3 s). When getting out of range, the scanner will respond with three short beeps (tone
descending from high to low).
Read the “Set Connection” label first, and then the “Serial Number” label. If the “Set
Connection” label on 3656 is illegible, try this one —
Set Connection
Note: The 3656 settings will overwrite the interface-related settings on the scanners that
are currently connected to 3656.
Users can also scan a single 2D barcode that combines the “Set Connection” and “Serial
Number” setup barcodes to connect to 3656. The example below is a 2D barcode
containing codes ‘#@CipherLab’, ‘88686471166254’ (Set Connection) and ‘BN1008213’
(Serial Number of 3656). Underlining the digits is to make them more readable.
#@CipherLab88686471166254
BN1008213

CipherLab 1564 Specifications

General

Type	Handheld bar code reader
Wavelength	625 nm
Sensor type	CCD
Read rate (max)	60 reads/s
Tilt reading angle	-60 - 60 °
Optical sensor resolution	752 pixels
Linear (1D) barcodes supported	Codabar, Code 128, Code 39, Code 93, EAN-13, EAN-8, GS1-128 (UCC/EAN-128), MSI, U.P.C.
2D (matrix & stacked) barcodes supported	Aztec Code, Composite Codes, Data Matrix, MaxiCode, Micro QR Code, MicroPDF417, PDF417, QR Code, TLC-39
Wireless range	90 m
Bluetooth version	2.0+EDR
Operating frequency	2400 MHz
Standard interfaces	Bluetooth
Connectivity technology	Wired & Wireless
Certification	BSMI, CE, C-tick, FCC, IC, NCC, KC, SRMC, TEL
Product color	Black
Housing material	Thermoplastic urethane (TPU)
Protection features	Shock resistant
International Protection (IP) code	IP30
Battery life	16 h
Input voltage	5 V
Battery voltage	3.7 V
Battery capacity	800 mAh
Power consumption	230 mA
Power source type	Battery, DC
Storage temperature (T-T)	-20 - 60 °C
Operating temperature (T-T)	0 - 50 °C
Operating relative humidity (H-H)	10 - 90 %

Weight and Dimensions

Depth	153 mm
Width	61 mm
Height	93 mm
Weight	185 g