51
Update
In order to establish a proper connection between your computer and the scanner, we
suggest that you follow these instructions –
1) Install the battery and hold down the trigger for about 2 seconds to turn on the
scanner.
2) Have the scanner read the “Enter Setup” barcode to enter the configuration mode.
3) Have the scanner read the associated barcodes to activate the desired interface. See
the following sections for output interfaces supported.
4) Have the scanner read the barcodes for related settings.
5) Have the scanner read the “Update” barcode to exit the configuration mode.
6) Turn on your computer or laptop and establish a WPAN connection with the scanner.
Refer to
Chapter 3 – Setting up a WPAN Connection.
Note: By default, the output interface is set to “BT HID”.
IN THIS CHAPTER
2.1 BT HID..................................................................... 52
2.2 BT SPP Slave............................................................. 63
2.3 BT SPP Master........................................................... 66
2.4 Keyboard Wedge via 3656 .......................................... 70
2.5 RS-232 via 3656........................................................ 81
2.6 USB HID via 3656...................................................... 86
2.7 USB Virtual COM via 3656........................................... 96
Chapter 2
SELECTING OUTPUT INTERFACE
To Next Page
Loading...
Need help?
General
Weight and Dimensions
