50
Enter Setup
1564 Barcode Scanner
User Guide
1.16 SERIAL NUMBER STAMP
Decide whether to add the device serial number in front of the data transmitted.
Add serial number in
front of data
*Disable
1.16.1 SEPARATOR BETWEEN SERIAL NUMBER STAMP AND DATA
Scan the barcode below to specify the separator character between device serial number
and the accompanying data. By default, the separactor is a comma symbol.
Specify the
separator character
1) Read the barcode above to specify a separator character.
2) Read the “
Hexadecimal Value” barcode on page 264 for the desired character.
3) Read the “Validate” barcode to complete this setting.
To Next Page
Loading...
