12
Enter Setup
1664 Barcode Scanner User Guide
DEFAULT SETTINGS
SAVE USER SETTINGS AS DEFAULTS
For the scanner to keep the customized settings as user defaults, you must read the
“Save as User Defaults” barcode. This is a normal setup barcode, and the scanner will
respond with two beeps (low-high tone).
After reading the “Update” barcode, the current settings will be saved as user
defaults.
ave as User
Defaults
RESTORE USER DEFAULTS
For the scanner to restore the user defaults, which you have saved earlier, you must
read the “Restore User Defaults” barcode. This is a normal setup barcode, and the
scanner will respond with two beeps (low-high tone).
After reading the “Update” barcode, all the parameters of the scanner will return to
their customized values.
Restore User
Defaults
RESTORE SYSTEM DEFAULTS
For the scanner to restore the factory defaults, read the “Restore System Defaults”
barcode. This is a normal setup barcode, and the scanner will respond with two beeps
(low-high tone). After reading the “Update” barcode, all the parameters of the scanner
will return to their default values. The current connection record will be cleared as well.
Refer to
1.18.1 Restore System Defaults for the key combination used to restore defaults
during operation.
For 3610 to restore factory defaults, refer to
3610 Setup Barcodes & Serial Commands.
Restore System
Defaults
Note: The system default value (if there is one) for each setting is indicated by an
asterisk “*”.
To Next Page
Loading...
Need help?
General
