39
Update
Chapter 1
Understandin
he Barcode Scanner
1.8 SCANNING TIMEOUT
Specify the scanning time interval (1~254 sec.; 0= Disable) when the scan mode is set
to any of the following –
Laser mode
Auto Off mode
Auto Power Off mode
Aiming mode
Scanner Time-out
fter 0~254 sec.
(*10)
1) Read the barcode above to specify the time interval in seconds before the scan
engine times out.
2) Read the “
Decimal Value” barcode on page 251. For example, read “1” and “5” for the
scanner to shut down automatically after being idle for 15 seconds.
3) Read the “Validate” barcode on the same page to complete this setting.