CipherLab 1664 User Manual

34
Enter Setup
1664 Barcode Scanner User Guide
1.4.3 LOW BATTERY ALARM
By default, the built-in battery alarm will sound when the battery charge gets low. In
order to prevent data loss, it is advised to replace the battery immediately when hearing
two short beeps (high tone).
Disable
*Enable
1.5 VIBRATOR
1.5.1 GOOD READ VIBRATOR
E
nable
Good Read Vibrator
*
Disable
Good Read Vibrator
1.5.2 GOOD READ VIBRATOR DURATION
By default, the Good Read Vibrator stays on for 1 second. Specify a value, ranging from
1 to 254 in units of 100 milliseconds.
Good Read Vibrator
Time-out after
0
.1~25.4 sec.
(*1 s)
1) Read the barcode above to specify the time interval, in tenths of seconds before the
Good Read Vibrator goes off.
2) Read the “
Decimal Value” barcode on page 251. For example, read “1” and “5” for the
vibrator to vibrate after 1.5 seconds good read.
3) Read the “Validate” barcode on the same page to complete this setting.

CipherLab 1664 Specifications

General

Brand	CipherLab
Model	1664
Category	Barcode Reader
Language	English