To Next Page

To Previous Page

Enter Setup

1664 Barcode Scanner User Guide

1.14 PICKLIST MODE

Picklist mode enables the decoder to decode only the barcodes aligned under the center

of the laser aiming pattern.

Enable

*Disable

1.15 PAGER BEEP DURATION

Paging function is only activated when 1664 is in Power-Saving mode. 1664 can be

woken up via receiving any Bluetooth

status command by pressing a key on the host

keyboard. The buzzer will continuously sound two short high tone beeps until the power

key is pressed on the scanner or the timeout is reached, and the scanner re-enters

power saving mode.

By default, the pager beep duration is 5 seconds. Specify a value, ranging from 0 to 15.

(0~15 sec.; 0= Disable)

 Bluetooth

HID profile: Press any one of the following keys “Scroll Lock”, “Number

Lock” or “Caps Lock” on the host computer to trigger the waking up of 1664.

 Bluetooth

SPP Profile: Any command sent using Bluetooth

SPP will trigger the

waking up of 1664.

Pager Beep Duration

~15 sec.

(*5 s)

1) Read the barcode above to specify the desired beep active time.

2) Read the “

Decimal Value” barcode on page 251. For example, read “1” and “5” for the

pager beep function to be activated each 15 seconds after entering Power-Saving

mode.

3) Read the “Validate” barcode on the same page to complete this setting.

CipherLab 1664 User Manual

Questions and Answers: